15N20 is a nickel-alloyed carbon steel best known as the bright layer in Damascus. It was originally made for bandsaw blades.
15N20 Steel at a Glance
| Type | Carbon steel |
|---|---|
| Made by | Uddeholm and other mills |
| Typical hardness | 58-62 HRC |
| Key elements | Carbon about 0.75%, nickel about 2%, manganese about 0.4% |
| Edge retention | 2/10 (low) |
| Toughness | 9/10 (excellent) |
| Rust resistance | 2/10 (low) |
| Ease of sharpening | 9/10 (very easy) |
| Best for | Damascus and tough blades |
Ratings are relative 1 to 10 scores for typical factory heat treatments. See how 15N20 ranks against 46 other steels in our Knife Steel Chart.
What Is 15N20 Steel?
The 2% nickel improves toughness and resists etching, which is why it stays bright in Damascus patterns.
15N20 Steel Properties
- Edge retention: Low.
- Toughness: Excellent.
- Rust resistance: Low. Keep it dry and lightly oiled.
- Ease of sharpening: Very easy.
15N20 vs Other Steels
15N20 vs 1084
Compared with 1084, 15N20 is slightly tougher and resists rust slightly better. 1084 holds an edge slightly longer. Read our 1084 guide.
15N20 vs 5160
Compared with 15N20, 5160 is slightly tougher. Read our 5160 guide.
15N20 vs 1095
Compared with 1095, 15N20 is tougher and resists rust slightly better. 1095 holds an edge slightly longer. Read our 1095 guide.
Is 15N20 Steel Good for Knives?
Yes, especially in Damascus or for tough working blades.
Pros:
- Very tough
- Easy to sharpen
- Great for Damascus
Cons:
- Not stainless
- Modest edge retention
Knives That Use 15N20 Steel
Makers sometimes change blade steels between versions, so check the listing to confirm the steel before you buy.
Frequently Asked Questions
Is 15N20 steel stainless?
No. 15N20 is not stainless and will rust or patina if left wet. Keep it dry and lightly oiled.
How hard is 15N20 steel?
Knives in 15N20 are usually heat treated to around 58-62 HRC.
Is 15N20 easy to sharpen?
Very easy. Most standard stones and pull-through sharpeners work.